Furnace Life Expectancy: How Long a Furnace Lasts and When to Plan for a New One

In Fargo-Moorhead, the furnace may be the most important appliance in the house. Furnace life expectancy tells you roughly how many winters you can count on before a replacement, and whether the furnace in a home you are buying is likely to need one soon. In the inspections we reviewed for this series, about one in five homes had a furnace or air conditioner past its expected life.

This guide covers how long furnaces usually last, what wears them out, the warning signs to watch for, what “past life expectancy” means when it shows up in an inspection report and how to get the most years out of the furnace you have.

How long does a furnace last?

Life expectancy is a range, not a promise. It assumes the furnace was sized and installed correctly and maintained. These are the figures from sources we trust:

SourceWhat it says
InterNACHI life expectancy chartFurnace: 15 to 25 years. Heat exchanger: 10 to 15 years.
Minnesota Department of CommerceMost furnaces have a useful life of 15 to 20 years, depending on conditions.
ENERGY STARConsider replacing a furnace that is more than 15 years old.

InterNACHI points out that life expectancy varies with usage, weather, installation, maintenance and quality, and that its chart is a guideline, not a guarantee. In our climate, a furnace runs for much of the year, so it puts on more hours than the same model in a mild climate.

What wears out a furnace

A gas furnace burns fuel in a sealed combustion chamber and passes the heat through a heat exchanger to the air that moves through your ducts. The flue gases stay on the other side of the heat exchanger and leave through the vent. Over many heating seasons, that metal heats and cools thousands of times. Rust and cracks can develop, which is why heat exchangers are inspected during a tune-up.

Moving and electrical parts wear too: blower motors, inducer fans, igniters, flame sensors and control boards. Most of these can be replaced. When the repairs start to add up on an older furnace, though, it may be time to replace it instead. The Minnesota Department of Commerce suggests replacing rather than repairing if you would be spending 25% or more of the cost of a new furnace on repairs.

Signs your furnace is wearing out

ENERGY STAR lists these signs that it may be time for new heating equipment:

  • Frequent repairs and rising energy bills
  • Some rooms that are too hot or too cold
  • Humidity problems in the home
  • Excessive dust
  • A noisy heating system

Other warning signs we look for during an inspection include rust or water in the cabinet, soot around the burners or vent, and burner flames that are yellow or wavering instead of steady and blue. InterNACHI notes that flames that waver when the blower starts can point to a cracked heat exchanger. Any of these deserves a call to a licensed HVAC contractor.

Carbon monoxide: why furnace age matters for safety

The U.S. Department of Energy warns that combustion gases leaking into the house can cause carbon monoxide (CO) poisoning, and the Minnesota Department of Commerce lists a cracked heat exchanger as one cause. CO has no smell, and its symptoms are similar to the flu without the fever: headache, fatigue, shortness of breath, nausea and dizziness.

The Consumer Product Safety Commission recommends CO alarms on each level of the home and outside sleeping areas, and Minnesota law requires a CO alarm within 10 feet of each bedroom. Test them monthly. Our article on smoke and carbon monoxide detectors covers the basics. If a CO alarm sounds, get everyone outside and call 911 or your gas utility from there.

How to tell how old your furnace is

The data plate inside the furnace door lists the model and serial number. Many manufacturers build the date of manufacture into the serial number, and each brand uses its own code. The manufacturer’s website or customer service can decode it. Service stickers on the cabinet, permits and the original paperwork help too.

What “past life expectancy” means in an inspection report

When we note that a furnace is nearing or past its life expectancy, we are not saying it is broken. Many older furnaces are still heating well on inspection day. It means the furnace has reached an age where failures become more likely, and you should plan and budget for replacement.

A home inspection checks the furnace’s operation, venting, visible components and safety controls. We don’t take the furnace apart, and we can’t see the whole heat exchanger. That is why we often recommend that a licensed HVAC contractor evaluate an older furnace, ideally before closing or before winter. For one older design where testing matters, see our post on the Lennox Pulse furnace.

Replacing an older furnace

Newer furnaces are much more efficient. The Department of Energy notes that older, low-efficiency systems run at about 56% to 70% AFUE (annual fuel utilization efficiency), while high-efficiency furnaces reach 90% to 98.5%. High-efficiency furnaces are condensing models that vent through PVC pipe instead of a chimney.

The Minnesota Department of Commerce recommends asking for a heat-loss calculation as part of any contract, because an oversized furnace cycles on and off more often. Planning ahead lets you compare bids and options instead of replacing a furnace in an emergency on a January night.

How to get the most life out of your furnace

  1. Have the furnace serviced every year, ideally in the fall, as ENERGY STAR recommends. A tune-up includes checking gas connections, gas pressure, burner combustion and the heat exchanger. Our post on annual furnace service explains what a good tune-up covers.
  2. Check the filter every month. ENERGY STAR says a dirty filter can increase energy costs and damage your equipment, leading to early failure. Replace it as needed.
  3. Keep the intake and exhaust pipes clear. On high-efficiency furnaces, the Minnesota Department of Commerce warns that snow, nests or plants can block the pipes. Check them after heavy snow.
  4. Keep the area around the furnace clear, and make sure the furnace disconnect switch is easy to reach and labeled.
  5. Listen and look. New noises, short cycling or rooms that won’t stay comfortable are reasons to call for service early. Our DIY health check for your furnace lists simple checks you can do yourself.

Your air conditioner shares the furnace’s blower, filter and ductwork, so the two often age together. See our companion posts on AC life expectancy and water heater life expectancy.

Furnace life expectancy: common questions

How long does a furnace last?

Most furnaces last about 15 to 25 years, according to InterNACHI, and the Minnesota Department of Commerce says 15 to 20 years is typical. Yearly service helps a furnace reach the long end of that range.

Should I replace a furnace just because it is 20 years old?

Not necessarily. An older furnace that runs safely and has been maintained can keep going. But repairs become more likely, and a new furnace can use much less fuel. Have a licensed HVAC contractor evaluate it and compare the cost of repairs with replacement.

Is a cracked heat exchanger dangerous?

It can be. A cracked heat exchanger can let combustion gases, including carbon monoxide, into the air in your home. If a contractor finds one, follow their advice, and make sure your CO alarms are working.

Does “past life expectancy” mean the seller has to replace the furnace?

No. It is information for planning, not a requirement. Whether to ask for a further evaluation, a repair, a credit or nothing at all is a decision for you and your real estate agent.

Want to know the age and condition of your furnace and the rest of your home’s systems? Schedule a homeowner inspection, or learn more about our home buyer’s inspection.

Sources